[SEL] Buzz saw

[David Rotigel]

> Hi Andy, Start the bend at the gullet. The tip of the tooth should  
> be about 1/16 out. Be sure to bend each tooth the proper way. The  
> current set should tell you which way that is.
	Dave
>
>
>
> Thanks Dave, My blade is 1/8" thick so the amount of set that you  
> recommend will work good. I was getting ready to use a small monkey  
> wrench that I have. I may even make a wrest buy cutting a slot into  
> a piece of bar stock.  How far down should I bend the teeth?  Do I  
> only bend it near the tip? about 1/2 way or all of the way down to  
> the gullet? My blade is 1/8" thick so the amount of set that you  
> recommend will work good.