[SEL] IHC BIG END BEARING

[SERVICE]

Thanks Tom, that gives me another option,
Chester

----- Original Message ----- 
From: <Germoamer at aol.com>
To: <sel at lists.stationary-engine.com>
Sent: Thursday, January 10, 2008 10:46 AM
Subject: Re: [SEL] IHC BIG END BEARING


> Chester,
>
> I had the same thing on my 6 Famous, I machined the laps where the 
> bearings
> fit together until the worn(largest worn diameter) area was now the 
> diameter of
> the crankshaft.  Of course this still makes the hole in the bronze oval
> shape.  Correct this by machining out the bronze to the correct diameter 
> of the
> crank and rework the radiuses on the edges. Put in a few thousands shims 
> when
> putting it on the crank and it should last another hundred years.
>
>
> Tom Schmutz
> Concord, Va.
> Germoamer at aol.com
>
>
>
> **************Start the year off right.  Easy ways to stay in shape.
> http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel