[SEL] Gib key puller

[Edd Payne]

Very well done Jerry and the article is well presented and easy to follow.
EDD PAYNE
PO Box 364 Gulgong N.S.W
Australia
2852
Phone:0263742387
edsengns at optusnet.com.au
edsengns
----- Original Message ----- 
From: "Jerry Evans" <jerrye at databak.co.za>
To: <sel at lists.stationary-engine.com>
Sent: Saturday, May 05, 2007 5:39 AM
Subject: [SEL] Gib key puller


> Hi Guys,
>         There have been many discussions about removing Gib keys on the 
> lists.
>         I needed something to pull the key on my restored Ruston & Hornsby
> because it had an oil leak on the timing gear cover.
>         This cover is right up against the inside of the flywheel and
> there is no way of removing it without removing the flywheel.
>         I did not want to use anything that would damage the paint on the
> flywheel.
>         Here is what I came up with:
>
> <http://www.oldengine.org/members/evans/gibpull/index.htm>
>
>         I hope it is of help to someone.
>
>
> Keep the revs up (or down)
> Jerry Evans
> Near Johannesburg in Sunny South Africa.
> Tel. (016) 365-5787
> Intntl.: +2716 365-5787
> Cell: 083 293 7191
> Visit our website for old engines in South Africa.
> www.oldengine.org/members/evans
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel