[SEL] Gasket material for oilers?

[R & M Ingold]

They work ok when I have had to use them.
You dont need em over tight to hold the oil in.
Another thing is if you get long ones, they can be cut and glued with 
superglue. So you can make the size you need.
There are all diameters available. I have some 1/16 long ones that get cut n 
glued as needed, along with the bigger sizes.
Reg & Marg Ingold.
Newcastle, NSW, Australia.
randmingold at hotkey.net.au
http://www.oldengine.org/members/randmingold

----- Original Message ----- 
From: <bill at antique-engines.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Wednesday, May 02, 2007 10:00 PM
Subject: Re: [SEL] Gasket material for oilers?


> Yeah, thanks - will have to give them a try.
> Any preference as to the diameter, thick or thin? Will they "roll inward"
> when you snug things down?
>
> Bill
>
>> Never thought about O-rings Reg, thanks.
>>
>> Paul
>>
>> ----- Original Message -----
>> From: "R & M Ingold" <randmingold at hotkey.net.au>
>> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
>> Sent: Tuesday, May 01, 2007 9:26 PM
>> Subject: Re: [SEL] Gasket material for oilers?
>>
>>
>>>O rings
>>> Reg & Marg Ingold.
>>> Newcastle, NSW, Australia.
>>> randmingold at hotkey.net.au
>>> http://www.oldengine.org/members/randmingold
>>>
>>> ----- Original Message -----
>>> From: "Paul Maples" <paulmaples at sbcglobal.net>
>>> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
>>> Sent: Wednesday, May 02, 2007 11:38 AM
>>> Subject: [SEL] Gasket material for oilers?
>>>
>>
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>