[SEL] Gasket material for oilers?

bill at antique-engines.com bill at antique-engines.com
Wed May 2 05:00:56 PDT 2007


Yeah, thanks - will have to give them a try.
Any preference as to the diameter, thick or thin? Will they "roll inward"
when you snug things down?

Bill

> Never thought about O-rings Reg, thanks.
>
> Paul
>
> ----- Original Message -----
> From: "R & M Ingold" <randmingold at hotkey.net.au>
> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Tuesday, May 01, 2007 9:26 PM
> Subject: Re: [SEL] Gasket material for oilers?
>
>
>>O rings
>> Reg & Marg Ingold.
>> Newcastle, NSW, Australia.
>> randmingold at hotkey.net.au
>> http://www.oldengine.org/members/randmingold
>>
>> ----- Original Message -----
>> From: "Paul Maples" <paulmaples at sbcglobal.net>
>> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
>> Sent: Wednesday, May 02, 2007 11:38 AM
>> Subject: [SEL] Gasket material for oilers?
>>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>




More information about the sel mailing list