[SEL] Kwik Poly Sealer

[Richard Fink Sr]

Skip do you have a few extra thousand laying around. If so i will try that.
LOL
R Fink

At 05:55 PM 7/27/2007 -0400, you wrote:
>You know what?
>You could keep pouring that stuff in like you say until the tank will no
>longer be able to hold any gas to leak out.
>That would work.
>Skip
>----- Original Message -----
>From: "Rob Skinner" <rskinner at rustyiron.com>
>To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
>Sent: Friday, July 27, 2007 11:20 AM
>Subject: Re: [SEL] Kwik Poly Sealer
>
>
> >
> > On Jul 27, 2007, at 4:47 AM, Curt wrote:
> >> To avoid the re-stick issue that Dave
> >> mentioned, one could mix another portion and pour it in just as the
> >> first batch was beginning to thicken, but not set yet. By getting the
> >> timing right where you are pouring new material in over setting
> >> material,
> >
> > Hey Curt,
> > I've done exactly as you described:  pour it in, let it set up, pour
> > some more in, let it set up, pour some more in, tire of he process
> > and call it good.  I suspect the "no stick" instructions might be
> > referring to KP that has completely set up and is like a rock.  That
> > takes hours to happen.
> >
> > Rob
> >
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> >
> >
> > --
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.5.476 / Virus Database: 269.10.22/922 - Release Date: 7/27/2007
> > 6:08 AM
> >
> >
>
>_______________________________________________
>SEL mailing list
>SEL at lists.stationary-engine.com
>http://www.stationary-engine.com/mailman/listinfo/sel