[SEL] Re: A few flask dimensions for Tod Works Foundry

[Curt]

Well I don't know why those didn't hyperlink correct?? Try this
<http://www.oldengine.org/members/holland/images/RicksFlasks/18%20x%2012.bmp>
<http://www.oldengine.org/members/holland/images/RicksFlasks/20%20x%2012.bmp>
<http://www.oldengine.org/members/holland/images/RicksFlasks/24%20x%2010.bmp>

Hope this works,
Curt

> Dave,
> As promised earlier here are 3 flask sizes/drawings for parts cast by 
> TWF.
>
> http://www.oldengine.org/members/holland/images/RicksFlasks/18 x 12.bmp
> http://www.oldengine.org/members/holland/images/RicksFlasks/20 x 12.bmp
> http://www.oldengine.org/members/holland/images/RicksFlasks/24 x 10.bmp
>
> Since your pattern is 13" long I would think that the 20 x 12 would be 
> the best choice. You'll offset the pattern leaving more room on the 
> crown side providing room for the riser, gate, and down sprue. Hot 
> metal should be no closer than 1 1/2" from the inside flask dimensions.
>
> Rick will eventually proof and move these sketches over to his website 
> for easier access.
> Curt
>