[SEL] A few flask dimensions for Tod Works Foundry

[Curt]

Dave,
As promised earlier here are 3 flask sizes/drawings for parts cast by TWF.

http://www.oldengine.org/members/holland/images/RicksFlasks/18 x 12.bmp
http://www.oldengine.org/members/holland/images/RicksFlasks/20 x 12.bmp
http://www.oldengine.org/members/holland/images/RicksFlasks/24 x 10.bmp

Since your pattern is 13" long I would think that the 20 x 12 would be 
the best choice. You'll offset the pattern leaving more room on the 
crown side providing room for the riser, gate, and down sprue. Hot metal 
should be no closer than 1 1/2" from the inside flask dimensions.

Rick will eventually proof and move these sketches over to his website 
for easier access.
Curt