[SEL] 12 volt 2000 lbs winch

[peter ogborne]

Alan ,as a matter of interest ,does it have made in China on it.? These 
winches are available here and also seem to be OK.
----- Original Message ----- 
From: "Alan Bowen" <rustaholic777 at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Sunday, October 02, 2005 6:07 AM
Subject: Re: [SEL] 12 volt 2000 lbs winch


> As I wrote before,,,,,  A little more info.
> I used mine to drag a 1640 pound metal lathe down a set of planks and 
> across a concrete floor.  The lathe was on a pair of 2X12 planks and the 
> planks are what slid across the floor.  That is a lot of surface area, but 
> it worked great.
>
> NO,  It is NOT to be used for vertical lifting.
> It is a Winch  NOT a Hoist.
>
> Play safe.
>
> Alan Bowen  rustaholic777 at yahoo.com
> Williamsburg, Michigan
>
> Germoamer at aol.com wrote:
> In a message dated 9/30/2005 11:47:45 PM Eastern Daylight Time,
> Frank at lbpinc.com writes:
>
> << (The 2000 lb is said to be "Up to 6000 lbs. pulling capacity for 
> rolling
> stock, 2000 lbs. for straight pulling' Straight pulling what, on what
> surfacer.) >>
>
>
> I would think they meant 2000 lbs lifting capacity, but I would contact 
> them
> to verify.
>
> Tom Schmutz
> Concord, Va. USA
> Germoamer at aol.com
>
>
> ---------------------------------
> Yahoo! for Good
> Click here to donate to the Hurricane Katrina relief effort.
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
>