[SEL] ZD bearings

[Bill Boyce]

rick,,,, only the con rod has shims,, the manual says the crank and cam
bearing clearance is to be obtained by filing the bearings, and there is no
listing for crank or cam bearing shims in the parts listing,,,,,,
bill



----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Sunday, March 06, 2005 4:19 AM
Subject: Re: [SEL] ZD bearings


> Although I've never had one apart, wouldn't the shims keep them from
> turning?
>
> RickinMt.
>
>
> ----- Original Message ----- 
> From: "Bill Boyce" <bboyce at swat.coop>
> To: "stationary engine list" <sel at lists.stationary-engine.com>
> Sent: Saturday, March 05, 2005 7:49 PM
> Subject: [SEL] ZD bearings
>
>
> hello all,, my son is rebuilding a ZD for a neighbor and has run into a
> problem,,, new crank bearings were ordered from hit and miss, but there is
> no way to prevent them from turning in the bores,,,,, it looks like the
> original bearings had a tab on the inside lip that meshed with a notch in
> the brearing cap to prevent them from spinning,,,,,has anyone run into
this
> problem? and what was done to correct it ? i;m going to call Ed monday,
but
> thought i mite get some ideas here too,,,, thanks in advance for any help.
> bill boyce
> lost prairie, arkansas
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
>