[SEL] Belting question?

[Dave Rotigel]

Twice as long as half will also give you a good idea of the belts length. 
Additionally you could tell the owner of the belt that you would give him a 
dollar if he told you the length of the belt. As a last resort you could 
lay the belt out on the ground and measure it. If you then would multiply 
your finding by 2 you would have a pretty good idea of the total length!
         Dave

At 06:33 PM 6/1/2005, you wrote:
>Mike ,Try 3.14x dia. of each coil. Add up the sum of each calculation. You
>should come pretty close. Cya, Jimmy O'Hagan
>
>Jim O'Hagan
>-----Original Message-----
>From: sel-bounces at lists.stationary-engine.com
>[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Mike Rohrer
>Sent: Wednesday, June 01, 2005 12:35 PM
>To: 'The SEL email discussion list'; 'Steam-engine mailing list'
>Subject: [SEL] Belting question?
>
>What is the calculation to figure the length of flat belting rolled up?
>
>Thanks
>
>Mike