[SEL] Sorta O/T..gear making

[Tod Engine]

Maybe, maybe not.  Depends upon where the missing teeth are at and if a 
couple of tricks up my sleeve would work.   If it didn't work yes I could 
also make a blank to be machined.

Rick
----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Thursday, January 27, 2005 8:48 AM
Subject: Re: [SEL] Sorta O/T..gear making


> Rick, wouldn't you have to pour a blank as I have some teeth missing...and 
> then I'd have to have the teeth milled?
>
> Rick
>
>
> ----- Original Message ----- 
> From: "Tod Engine" <todengine at zoominternet.net>
> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Wednesday, January 26, 2005 3:55 PM
> Subject: Re: [SEL] Sorta O/T..gear making
>
>
>> Well I could sure give it a try. They should come out ok if not too awful
>> small.
>>
>> Rick Rowlands
>>
>> ----- Original Message ----- 
>> From: "Richard Strobel" <Richard_Strobel7 at msn.com>
>> To: "SEL email discussion list" <sel at lists.stationary-engine.com>
>> Sent: Wednesday, January 26, 2005 10:35 AM
>> Subject: [SEL] Sorta O/T..gear making
>>
>>
>> > Howdy again;
>> > What is the best route to take to get gear(s) made?  One is a 
>> > combination
>> > i.e. two gears, one casting.  I also need a smaller gear...all straight
>> > cut teeth.  This is for manually traversing the carriage on my ole 
>> > lathe.
>> > Could the old ones be used for a pattern and is this something Rick
>> > Rowlands could do?
>> >
>> > TIA
>> > RickinMt.
>> >
>> > http://community.webshots.com/user/stroberc
>> > _______________________________________________
>> > SEL mailing list
>> > SEL at lists.stationary-engine.com
>> > http://www.stationary-engine.com/mailman/listinfo/sel
>> >
>>
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>