[SEL] Sorta O/T..gear making

[Richard Strobel]

Rick, wouldn't you have to pour a blank as I have some teeth missing...and 
then I'd have to have the teeth milled?

Rick


----- Original Message ----- 
From: "Tod Engine" <todengine at zoominternet.net>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Wednesday, January 26, 2005 3:55 PM
Subject: Re: [SEL] Sorta O/T..gear making


> Well I could sure give it a try. They should come out ok if not too awful
> small.
>
> Rick Rowlands
>
> ----- Original Message ----- 
> From: "Richard Strobel" <Richard_Strobel7 at msn.com>
> To: "SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Wednesday, January 26, 2005 10:35 AM
> Subject: [SEL] Sorta O/T..gear making
>
>
> > Howdy again;
> > What is the best route to take to get gear(s) made?  One is a 
> > combination
> > i.e. two gears, one casting.  I also need a smaller gear...all straight
> > cut teeth.  This is for manually traversing the carriage on my ole 
> > lathe.
> > Could the old ones be used for a pattern and is this something Rick
> > Rowlands could do?
> >
> > TIA
> > RickinMt.
> >
> > http://community.webshots.com/user/stroberc
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> >
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>