[SEL] Spam> Re: OT Japanese translation needed

[Richard Fink Sr]

Curt i have one and it is simple heat and low air pressure, plastic must 
have alike code on them as is on bottom of bucket,tells what kind 
plastic it is. Put two sections together apply heat with unit [just put 
close] melting it new plastic as needed.air appears help in flow 
together. hope this may help

R Fink Sr

PA


On 11/14/2016 7:57 AM, cgandree at mchsi.com wrote:
> Hi Guys,
> Recently I got a plastic welder and the darn instructions were written in Japanese.  Being a first time user I was needing
> some pre-training before using it. If some one out there can help me I would greatly appreciate the assistance.
> Thank you in advance,
> Curt Andree
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus