[SEL] Fuller & Johnson help needed

[Vivas1993 at aol.com]

Hey Curt,
Unless it's a very early engine, the numbers are only stamped on the  tag.
I've also got a couple of F&J engines that are missing their  tags.
 
Starbolt has the repo tags.
 
Dwight
 
 
In a message dated 7/7/2013 8:47:39 A.M. Eastern Daylight Time,  
cgandree at mchsi.com writes:

I have  finally brought out one of my back burner restoration projects a 
little Fuller  & Johnson engine that I bought at an estate sale some 15yrs 
ago. Believe  it to be a model N, 1 1/2hp. This previous owner had completely 
torn down the  engine and was planning to restore and get running so
all the parts were  still there.  It also has both the ignitor asy as well 
as the spark plug  asy so
its possible to run it either way.  I am chosing the ignitor  method.  When 
sorting through all the parts yesterday discovered that the  ID serial 
plate was missing off the hopper, just the two brass screws were  there. I can't 
remember if I bought it that way or have missplaced the tag. My  help 
question is does anyone know where the serial number might be stamped if  at all? 
 I have pretty much wire wheeled all the of the engine and  checked the 
most likely places like water hopper, flywheels, end of the crank  shafts and 
flat areas just forward the crank shaft.  Also who might have  repro tags?
thank you in advance,
Curt  Andree
_______________________________________________
SEL mailing  list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel