[SEL] lubricator cove

[k_armstrong1 at bigpond.com]

thanks russell,

i will possibly have to make one to fit.

thanks for reply
kevin

-----Original Message----- 
From: Russell
Sent: Tuesday, June 19, 2012 3:01 PM
To: The SEL email discussion list
Subject: Re: [SEL] lubricator cove

Hi Kevin, years ago I was in need of x2 glass covers for a 5hp S type 
Petter, Mate I hunted high and low and everywhere in between. All to no 
avail. You are spot on in relation to it being a triangle shaped glass cover 
with a square-ish bottom. Still to this day I have not found anyone who does 
them. I have seen some guys make a glass type lid out of flat cut pieces 
glued together. They are basically a dust cover only, I always just had an 
or rag tied around my oiler when not in use.

Russell


On 18/06/2012, at 8:41 PM, <k_armstrong1 at bigpond.com> wrote:

> Hello All,
>
> To complete the engine restoration I am in need of 2 plastic / glass 
> /Perspex covers for my Petter Atomic 5 HP diesel engine made in 1937 s/n 
> 223976.
>
> it is fitted with The Calibrator Lubricator System. these are triangle 
> shaped when looking from the side and have a base of approx. 25 mm square 
> or 1”.
>
> and any information on these engines.
>
> regards
>
> Kevin Armstrong
>
> k_armstrong1 at bigpond.com
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel


_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel