[SEL] lubricator cove

[Russell]

Hi Kevin, years ago I was in need of x2 glass covers for a 5hp S type Petter, Mate I hunted high and low and everywhere in between. All to no avail. You are spot on in relation to it being a triangle shaped glass cover with a square-ish bottom. Still to this day I have not found anyone who does them. I have seen some guys make a glass type lid out of flat cut pieces glued together. They are basically a dust cover only, I always just had an or rag tied around my oiler when not in use. 

Russell


On 18/06/2012, at 8:41 PM, <k_armstrong1 at bigpond.com> wrote:

> Hello All,
> 
> To complete the engine restoration I am in need of 2 plastic / glass /Perspex covers for my Petter Atomic 5 HP diesel engine made in 1937 s/n 223976.
> 
> it is fitted with The Calibrator Lubricator System. these are triangle shaped when looking from the side and have a base of approx. 25 mm square or 1”.
> 
> and any information on these engines.
> 
> regards
> 
> Kevin Armstrong
> 
> k_armstrong1 at bigpond.com
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel