[SEL] I just found a 5 3/4 inch piston out in my shop

[John & Beryl Cooper]

Hi Roger,
I replied direct to your address but the message bounced back, not
deliverable.
Thanks for the link, it looks similar.What measurement from piston top to
center of wrist pin.
How much wear is there. There appears to be some scuff marks on the lower
skirt.
Regards,
John Cooper.

-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Roger DiRuscio
Sent: Tuesday, 5 June 2012 12:44 AM
To: 'The SEL email discussion list'
Subject: Re: [SEL] I just found a 5 3/4 inch piston out in my shop


John Cooper,
I put the piston on eBay yesterday, take a look at it

Roger DiRuscio
-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of John & Beryl
Cooper
Sent: Sunday, June 03, 2012 10:42 PM
To: 'The SEL email discussion list'
Subject: Re: [SEL] I just found a 5 3/4 inch piston out in my shop

Hi Mark,
I have a 6 HP Bagshaw which appears to be a copy of a Fairbanks, I need a
new piston about that size.Wondering if it will fit.I can get the diameter
but would need to take the piston out to get the other measurements.
John Cooper,
BEGA,
Australia.



_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel