[SEL] Wico type EK magneto help wanted

[Rupert]

	Thanks Reg. That is what I thought.

Rueprt

Reg Ingold wrote:
> ALWAYS put a keeper across when you remove the bottom. NEVER taks the guts 
> out of a mag without doing this!
> Reg & Marg Ingold.
>> Newcastle, NSW, Australia.
>> randmingold at hotkey.net.au
>> http://www.oldengine.org/members/randmingold
> 
> ----- Original Message ----- 
> From: "Rupert" <rwenig2 at xplornet.com>
> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Saturday, October 24, 2009 3:28 PM
> Subject: Re: [SEL] Wico type EK magneto help wanted
> 
> 
>> Thanks. I did that. It is only about 1 thou out of round at the tip so
>> I figure that should work.
>> Is there any danger of loosing the magnet charge if I take the bottom
>> frame off so I can get a more accurate measurement?
>> Rupert
>>
>> Germoamer at aol.com wrote:
>>>
>>> Be sure and measure the shaft at 90deg as it is usually oval  shaped.  As
>>> someone said, a few thousands clearance should do the job.
>>>
>>> Tom  Schmutz
>>> Concord,  Va.
>>> germoamer at AOL.com
>>>
>> -- 
>>
>> yvt
>>
>> Rupert Wenig
>> Camrose, Alberta, Canada.
>>
>> email: rwenig2 at xplornet.com
>>
>> http://users.xplornet.com/~rwenig/Home/
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>>
> 
> 
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> 
> 
> ------------------------------------------------------------------------
> 
> 
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.423 / Virus Database: 270.14.28/2454 - Release Date: 10/23/09 14:09:00
> 

-- 

yvt

Rupert Wenig
Camrose, Alberta, Canada.	

email: rwenig2 at xplornet.com
	
http://users.xplornet.com/~rwenig/Home/