[SEL] Wico type EK magneto help wanted

[Reg Ingold]

ALWAYS put a keeper across when you remove the bottom. NEVER taks the guts 
out of a mag without doing this!
Reg & Marg Ingold.
> Newcastle, NSW, Australia.
> randmingold at hotkey.net.au
> http://www.oldengine.org/members/randmingold

----- Original Message ----- 
From: "Rupert" <rwenig2 at xplornet.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Saturday, October 24, 2009 3:28 PM
Subject: Re: [SEL] Wico type EK magneto help wanted


> Thanks. I did that. It is only about 1 thou out of round at the tip so
> I figure that should work.
> Is there any danger of loosing the magnet charge if I take the bottom
> frame off so I can get a more accurate measurement?
> Rupert
>
> Germoamer at aol.com wrote:
>>
>>
>> Be sure and measure the shaft at 90deg as it is usually oval  shaped.  As
>> someone said, a few thousands clearance should do the job.
>>
>> Tom  Schmutz
>> Concord,  Va.
>> germoamer at AOL.com
>>
> -- 
>
> yvt
>
> Rupert Wenig
> Camrose, Alberta, Canada.
>
> email: rwenig2 at xplornet.com
>
> http://users.xplornet.com/~rwenig/Home/
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>