[SEL] Etched brass plates.
Elden DuRand
edurand at mchsi.com
Thu Dec 17 07:26:27 PST 2009
Jerry:
I still need to know how much to send to Ron for the four plates you made for me.
As soon as I know, I'll cut a check and send it to him.
Take care - Elden
http://www.oldengine.org/members/durand
> -----Original Message-----
> From: sel-bounces at lists.stationary-engine.com
> [mailto:sel-bounces at lists.stationary-engine.com]On
> Behalf Of Jerry Evans
> Sent: Thursday, December 17, 2009 01:38 AM
> To: sel at lists.stationary-engine.com;
> stationary-engine at oldengine.org
> Subject: [SEL] Etched brass plates.
>
>
> Hi All,
> Unfortunately I have had to increase my
> prices on etched brass
> plates. Considering that this is the first real
> increase in 5 years I do
> not feel it is unjustified.
> Currency fluctuations and increases in
> the cost of my materials
> have forced me to do this.
>
> The most popular size is the smaller
> plate and this has only gone
> up US$ 1.00.
> The largest size I make has gone up US$ 5.00.
>
> The prices are (old price in brackets)
>
> Up to 100mm x 60mm @ US$ 20.00 each plus postage.
> (was US$ 19.00)
> Up to 100mm x 120mm @ US$ 32.00 each plus
> postage. (was US$ 29.00)
> Up to 100mm x 145mm @ US$ 40.00 each plus
> postage. (was US$ 35.00)
>
> These prices are also published on my webpage:
> <www.oldengine.org/members/evans/plates/index.htm>
>
> This will not affect any orders that I
> already have in hand - only
> new orders.
>
> I am busy etching another batch at
> present and should have all
> outstanding orders completed within a week.
>
> Keep the revs up (or down)
> Jerry Evans
> Near Johannesburg in Sunny South Africa.
> Etched Brass Engine Plates made to order:
> <www.oldengine.org/members/evans/plates/index.htm>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
More information about the sel
mailing list