[SEL] Etched brass plates.

[Bill Brueck]

A  bargain at any price.  I've bought a number of plates from Jerry and the
workmanship is superb.

Bill Brueck
   Chatfield, MN USA

-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Jerry Evans
Sent: Thursday, December 17, 2009 1:38 AM
To: sel at lists.stationary-engine.com; stationary-engine at oldengine.org
Subject: [SEL] Etched brass plates.

Hi All,
         Unfortunately I have had to increase my prices on etched brass 
plates. Considering that this is the first real increase in 5 years I do 
not feel it is unjustified.
         Currency fluctuations and increases in the cost of my materials 
have forced me to do this.

         The most popular size is the smaller plate and this has only gone 
up US$ 1.00.
         The largest size I make has gone up US$ 5.00.

The prices are (old price in brackets)

Up to 100mm x 60mm @ US$ 20.00 each plus postage. (was US$ 19.00)
Up to 100mm x 120mm @ US$ 32.00 each plus postage. (was US$ 29.00)
Up to 100mm x 145mm @ US$ 40.00 each plus postage. (was US$ 35.00)

These prices are also published on my webpage: 
<www.oldengine.org/members/evans/plates/index.htm>

         This will not affect any orders that I already have in hand - only 
new orders.

         I am busy etching another batch at present and should have all 
outstanding orders completed within a week.

Keep the revs up (or down)
Jerry Evans
Near Johannesburg in Sunny South Africa.
Etched Brass Engine Plates made to order:
<www.oldengine.org/members/evans/plates/index.htm>  

_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel