[SEL] Villiers C12A - 04 - 09

[Al Harris]

Thank you Barry and everybody else who offered assistance.

My report is:  I have never hit a Nut on the end of a shaft as hard as I 
hit this one and it was definitely a report. :-)

Now to attempt to fit it to my Mk12. :-\
> http://www.rustic-engines.com/media/pics/temp/Phelon-m.jpg

Cheers,

Al Harris
Spring Clarence Coast NSW Oz

al.harris at rustic-engines.com



Barry Gorman wrote:
> I have over thirty Villiers in most guises Seagull Outboard
> Engines are villiers motors .
> Undo The Nut (not me) A half turn  And Give The Nut A sharp Rap With A 
> hammer,
> Same goes to get the pulley off a victa mower <
> BARRY GORMAN
> GLORIOUS HUNTER VALLEY
> NEW SOUTH WALES, 2320
>
> ----- Original Message ----- From: "Al Harris" 
> <al.harris at rustic-engines.com>
> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Saturday, September 20, 2008 2:30 PM
> Subject: Re: [SEL] Villiers C12A - 04 - 09
>
>
>> I should have posted a photo Dave. My bad.
>>
>>> http://www.rustic-engines.com/media/pics/temp/Picture%20005m.jpg
>> The nut rests up against the flywheel, it is not an integral part of it.
>> As you can see there is nowhere to get leverage on the flywheel (we know
>> there must be though).
>> It is not like your standard Villiers flywheel eh.
>>
>> Cheers,
>>
>> Al Harris
>> Winter Clarence Coast NSW Oz
>>
>> al.harris at rustic-engines.com
>>
>