[SEL] Source for 8" flywheels

[jlb94 at juno.com]

Elden,
At the last show, I saw a guy that used Barbell Weights for flywheels.

Joe "Pip" Betz said that.
jlb94 at juno.com - - - www.oldengine.org/members/betz
   ,-._,-.      http://community.webshots.com/user/pipbetz
   \/)"(\/      
   (_o_)               " Buckle up and cut back ten".
 
On Sun, 11 May 2008 09:48:50 -0500 Clint D <driggars at wildblue.net>
writes:
> I can't find the link I had to a seller, but there is a seller on 
> Ebay 
> that sales all sizes reasonable, or most sizes, search for model 
> engine 
> fly wheels
> Clint
> 
> Elden DuRand wrote:
> > I am building a "Homebrew" flywheel engine and am looking for a 
> couple of cast-iron flywheels about 2-1/2" wide and 8" in diameter.  
> If they are finished and if necessary, I can bush them for the 
> crankshaft.  Unfinished castings would be better.
> >
> > Got any suggestions?
> >
> > Take care - Elden
> >
> > BTW, you can follow the progress of the engine at:
> > http://www.oldengine.org/members/durand/
> >
> >
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> >
> >   
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> 
>