[SEL] Source for 8" flywheels

[Orrin B Iseminger]

Gary Martin has a big selection of flywheels, but I don't recall anything in
his lineup that will clean up to 2½" width.

http://www.martinmodel.com/

http://www.martinmodel.com/products_services/flywheels/index.htm

Good luck!

Orrin

Orrin Iseminger
Colton, Washington, USA
http://users.moscow.com/oiseming/lc_ant_p/menu.htm
So many projects.  So little time.   

-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Elden DuRand
Sent: Sunday, May 11, 2008 7:10 AM
To: The SEL email discussion list
Subject: [SEL] Source for 8" flywheels

I am building a "Homebrew" flywheel engine and am looking for a couple of
cast-iron flywheels about 2-1/2" wide and 8" in diameter.  If they are
finished and if necessary, I can bush them for the crankshaft.  Unfinished
castings would be better.

Got any suggestions?

Take care - Elden

BTW, you can follow the progress of the engine at:
http://www.oldengine.org/members/durand/