[SEL] IHC BIG END BEARING

SERVICE edwards_service at westnet.com.au
Wed Jan 9 15:58:44 PST 2008


Hi, i am currently restoring a 8hp famous, its all going well untill i came to the big end, i was worried when i pulled it apart as it had no shims fitted, anyway it is really worn, probaly about 1/16 or more, as this is a bronze? block bearing, is there any fix?, could the bearings be welded up & milled out?, any ideas & comments welcome.
Cheers, 
Chester from West Aus.




More information about the sel mailing list