[SEL] Piston Size Needed for John Ames Stover

[Paul Maples]

Thanks Skip, I also forwarded this message to John. He may just want to go 
this way. I appreciate your help.

Paul

----- Original Message ----- 
From: "Skip Landis" <skipl130 at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Sunday, October 22, 2006 1:51 PM
Subject: Re: [SEL] Piston Size Needed for John Ames Stover


> paul, i think you would have to lengthen the rod by the difference in the 
> old & new deck height to maintajn the compression ratio. the rod is steel 
> or maliable iron, so adding a piece won't be a problem.  skip
>
> Paul Maples <paulmaples at sbcglobal.net> wrote:  Thanks Skip I Have 
> forwarded this information to John. Do you think it might
> work?
>
> Paul
> ----- Original Message ----- 
> From: "Skip Landis"
> To: "The SEL email discussion list"
> Sent: Saturday, October 21, 2006 7:22 PM
> Subject: Re: [SEL] Piston Size Needed for John Ames Stover
>
>
>> paul' i have a piston 5" by 5 3/4. 3 3/4 deck height with a 1 1/4 wrist
>> pin hole. skip
>>
>>