[SEL] Piston Size Needed for John Ames Stover

[Paul Maples]

Thanks Skip I Have forwarded this information to John. Do you think it might 
work?

Paul
----- Original Message ----- 
From: "Skip Landis" <skipl130 at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Saturday, October 21, 2006 7:22 PM
Subject: Re: [SEL] Piston Size Needed for John Ames Stover


> paul' i have a piston 5" by 5 3/4. 3 3/4 deck height with a 1 1/4 wrist 
> pin hole.  skip
>
> Paul Maples <paulmaples at sbcglobal.net> wrote:  Ok gang I now have all of 
> the necessary dimensions (I think) of the piston size that John Ames needs 
> for his 3 HP Stover:
>
> Diameter - 5.00 inches
> Height - 8.00 inches
> Wrist Pin Diameter - 1.375 inches
> Distance from center of wrist pin to top of piston - 4.500 inches
> The piston had (3) .375 inch rings.
>
>