[SEL] Need parts for Stover Fuel Pump?

[John Culp]

Paul, I've fixed a carb needle that was far further gone than that by 
dissolving the rust away with muriatic acid, coating the pitted surface 
with epoxy glue and screwing it into the previously release coated 
threads and seat of the carb body. I believe the same principle would 
work for you. Might have to use that grease gun to pump it back out.

John

On Oct 16, 2006, at 6:22 PM, Paul Maples wrote:

> Ok gang my nerves are finally settled down after the big explosion in 
> the shop so now I need your help again. Take a look at the plunger 
> that came out of the pump. There are two views of the plunger:
>
> http://i52.photobucket.com/albums/g36/wheelterrapin/StoverRebuild75.jpg
> http://i52.photobucket.com/albums/g36/wheelterrapin/StoverRebuild76.jpg


John Culp
Bristol, Tennessee, USA