[SEL] Babbitt bearings poured on the Alamo.

[Rick Rowlands]

How is the piston machining going?  Is the big piston going to have enough 
stock to finish up?

Rick

----- Original Message ----- 
From: "Curt" <curt at imc-group.com>
To: "SEL" <sel at lists.stationary-engine.com>; "SEL (Oldengine.org)" 
<stationary-engine at oldengine.org>; "OFES" <ofes at lists.stationary-engine.com>
Sent: Monday, May 01, 2006 12:57 PM
Subject: [SEL] Babbitt bearings poured on the Alamo.


> Folks this was a banner weekend! Accomplished a significant milestone in 
> the restoration of the Alamo engine by successfully pouring both the lower 
> and upper mains on this engine. I had done lowers before, but was 
> apprehensive about the uppers. As it turned out they were easier than the 
> lowers. Missy and I picture documented this as best we could and I've put 
> it on the website. Maybe it will be useful to someone when pouring theirs.
> Here is the link:
> http://www.oldengine.org/members/holland/images/AlamoBabbittPouring/Thumbnails.html
>
> Hope you enjoy.
> Curt Holland
> Gastonia, NC
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel