[SEL] bore and sleave an engine question
John Hall
jthall at worldnet.att.net
Sun Jul 9 04:16:56 PDT 2006
Heres an alternative to making a piston from a casting--especially if you
have to make the casting. Try making one out of a solid chunk of cast iron.
the only draw back I see would be having to relieve all the material between
the bosses where rod goes---probably go a little slow having to use
"extended" tooling. May not be real practical on big pistons but on the
little ones it should be faster than having to go through the process of
making castings-----unless you just want to do it. Then again, it's simpler
to just go buy a good engine than to restore a worn out basket
case-----unless you just want to do it.
John Hall
More information about the sel
mailing list