[SEL] New Way Mixer Re-Casting

[SERVICE]

Rick, the new way mixer i have copied for my 4.5hp is different to the 3.5hp
mixers you have shown, i dont know if all the 4.5hp ones are different, but
hopefully someone can tell us, thanks to your photos i have finished my fan
& shaft, cheers for now
Chester from West Aussie.

----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Saturday, December 31, 2005 1:02 AM
Subject: Re: [SEL] New Way Mixer Re-Casting


> Rick, I will work on getting the dimensions today, and some more pictures
of
> the mounting bracket.
>
>   Question please to all the New Way owners:
>
>  Ya'll know that there's no needle valve.  How do I remove what I'm going
to
> call "the main jet?" i.e. the brass tube with the small hole in the side?
> Are there TWO sets of male and female threads..one set on each side of the
> mixer?
>
>   I also think that on re-assembly the hole (jet) should be positioned
> straight up and then locked with the external lock nut.  Believe the air
> rushing around the circumference of the tube would create a low pressure
> area on the back side where the jet(hole) is, and this would create the
> "venturi effect."  Please correct me if I'm wrong.
>
> Well enuf fer now.
> Thanks
> RickinMt.
> PS:  Are there any decals available?
>
>
>
> > Rick,
> >
> >  What are the dimensions of the casting?  Can you get a picture that
shows
> > the mounting brackets?    What is the configuration of the interior of
the
> > part?  Would it be possible to cast it solid and just drill out the
> > passageways inside?  I do have some standard size round cores which I
> > could
> > possibly use to save you the trouble of making a core box.
> >
> > Rick Rowlands
> > Tod Engine Works
> > Makers of Quality iron, steel, ductile iron
> > and nonferrous castings
> > 2261 Hubbard Road
> > Youngstown, OH  44505
> > 330-728-2799
> > Fax 330-759-1524
> > www.todengine.org/engineworks.html
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel