[SEL] 2 Hp "ENGINE" question

Edd Payne edsengns at optusnet.com.au
Mon Dec 4 15:53:20 PST 2006


Hi Barry.Your engine badged "ENGINE" were usually a Rosebery rebadged .So 
everything applicable to a Rosebery would be the same.These are not hard to 
find.If it is a Rosebery Mag would be ether a Wico EK or a rotary M/L or BTH 
or Lucas RS1 or Fellows.Flywheel removal,Remove gib key and slide of wheel.
Timing ,standard 4 cycle valve timing,Open exhaust 35deg before outer 
centre,close top inner to 5deg after .Gov single wt in flywheel hit and 
miss.Some were throttlers but had a different carb.Hope this helps.
EDD PAYNE
PO Box 364 Gulgong N.S.W
Australia
2852
Phone:0263742387
edsengns at optusnet.com.au
edsengns
----- Original Message ----- 
From: "Barry Gorman" <BarryandPamGorman at bigpond.com>
To: <SEL at lists.stationary-engine.com>
Sent: Tuesday, December 05, 2006 9:15 AM
Subject: [SEL] 2 Hp "ENGINE" question


> From: Barry Gorman
> To: sel at lists.stationary-engine.com
> Sent: Monday, December 04, 2006 7:42 PM
> Subject: 2 Hp "ENGINE"
>
>
> wanted please ANY info on an open crank "ENGINE"
> 2 Hp .magy type,removal of flywheels, timing , govenor
> etc.
> thanks
>            Barry Gorman
>    Hunter Valley NSW  AUSTRALIA
>  BarryandPamGorman at bigpond.com
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> 




More information about the sel mailing list