[SEL] Help - Need Stover Part

[Paul Maples]

Steve the pictures you have included shows the more common "Center Pivot 
Point Arm", in other words the arms pivots on a shaft located almost in the 
center of the arm. If you will look at the picture I sent you the one I will 
have to have pivots on the end of the arm and not in the center. The center 
pivot arm mechanisms are very common to the Stover engines but the "end 
pivot arms" I am finding to be rare.

Are you saying that the pictures you attached to this message is the same 
engine that Curt is talking about?

Thanks for the help.

Paul


----- Original Message ----- 
From: "Steve Barr" <stevebarr at ameritech.net>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Tuesday, August 29, 2006 9:58 AM
Subject: Re: [SEL] Help - Need Stover Part


> Paul
>
> The engine that Curt is refering to has made the show circuit here in the
> midwest... Stover Reunion Freeport,IL (from what I heard)- Franklin
> Grove,IL - Sycamore, IL - Baraboo, IL.  It shows a repair and I don't know
> if it was original or a home made one.
>