[SEL] Re: Stover engine

[Curt]

Paul,
???? Didn't Edd Payne already send you the information on this?
Curt Holland
Gastonia, NC

Paul Maples wrote:

> Hello John,
>
> Thanks so much for the information but if the pictures below is the 
> engine everyone is talking about then the latch arm is the wrong one 
> for my engine.
>
> http://www.oldengine.org/members/sbarr/images/Shows/2006FranklinGrove/30.jpg 
>
> http://www.oldengine.org/members/sbarr/images/Shows/2006FranklinGrove/31.jpg 
>
>
> Here is an actual picture of the head on my engine that is missing the 
> latch arm, note that the pivot pin that the missing arm will pivot on 
> is located at one end of the head and not in the center:
>
> http://community.webshots.com/photo/2456860120049103604XiXPmT
> http://community.webshots.com/photo/163076625/2690034210049103604gnGyUt
>
> John this is why I feel the arm must be of the design shown on this 
> Stover head:
>
> http://community.webshots.com/photo/87694314/1088097993049103604waQDjh
>
> Have you ever seen a Stover head with this design latch arm on it? I 
> have been told that this latch arm was on a Model W or T Stover.
>
> Thanks for all of the help.
>
> Paul
>
> ----- Original Message ----- From: "John" <cjclem at sysim.net>
> To: "Paul Maples" <paulmaples at sbcglobal.net>
> Sent: Tuesday, August 29, 2006 1:07 PM
> Subject: Stover engine
>
>
>> Paul, The Frreport engine ( Stover) pictured on the list by Curt &
>> Steve Barr is owned by Gene & Betty DeCamp od Cottonwood,AZ. I spoke
>> with them at Baraboo<Wis show & they had engine there. They were going
>> home after that show,  no email so call them evening maybe. Here is
>> info:Eugene Decamp
>> 646 N Ocotillo St
>> Cottonwood, AZ 86326-8006
>> (928) 634-2740
>> Glad to help you out.  John in MN
>>
>>
>>
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
>