[SEL] just off the subject of Cold Cut

[cam grundy]

Hey Peter I saw fellow cutting Corrugated iron with a circular saw once with 
the blade in back the front ( it wasn't a tungsten tip one) and it did a 
great job, he was supposed to be a tradesman, but that was before all the 
new fangled tools were out. Cheers Cam
----- Original Message ----- 
From: "peter ogborne" <jopeter at omninet.net.au>
To: <sel at lists.stationary-engine.com>
Sent: Tuesday, September 20, 2005 8:45 PM
Subject: [SEL] just off the subject of Cold Cut


> What is a good method to cut corrugated iron sheet ,i.e. down the 
> corrugations?
> Abrasive disc makes too much bloody noise, hand nibbler so bloody slow, 
> aviation snips not bad ,but not ideal either!
> Peter Ogborne
> Little Grove ,Albany
> West Australia
> ''Heart of the Rainbow Coast ''
> jopeter at omninet.net.au
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>