[SEL] just off the subject of Cold Cut

[Andy]

Hi Peter. I've done the same thing, along and across, using an old circular
saw with the blade turned around, but don't use the type with the tips as
they shoot off every where. It dose make some noise but not for long. He He.
Andy.....

Andy Nicholson
Exmouth W.A.
Oz.
rustyiron at bigpond.com
----- Original Message ----- 
From: "peter ogborne" <jopeter at omninet.net.au>
To: <sel at lists.stationary-engine.com>
Sent: Tuesday, September 20, 2005 6:45 PM
Subject: [SEL] just off the subject of Cold Cut


> What is a good method to cut corrugated iron sheet ,i.e. down the
> corrugations?
> Abrasive disc makes too much bloody noise, hand nibbler so bloody slow,
> aviation snips not bad ,but not ideal either!
> Peter Ogborne
> Little Grove ,Albany
> West Australia
> ''Heart of the Rainbow Coast ''
> jopeter at omninet.net.au
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>