[SEL] Air Blow Off Nozzel Modification

R and E Freeman plb at iinet.net.au
Sun Sep 18 00:32:37 PDT 2005


I reckon any one of us Aussie's would find it no trouble at all to send one
over. The only difficulty would be your end with the thread for the air
fitting. Standard here is 1/4 BSPT where yours would be NPT. One is 18 and
the other 19 TPI. :D. Easy to run a tap through though.
Ray Freeman

-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Paul Maples
Sent: Sunday, 18 September 2005 8:59 AM
To: The SEL email discussion list
Subject: Re: [SEL] Air Blow Off Nozzel Modification

Andy I appreciate your offer but I do not want to impose on my good friend 
in Australia, if you were here in the states I might take you up on it but 
all the way to Australia is a bit much to ask of a friend. Thanks for 
offering Andy and I do appreciate it but I am not going to allow you to go 
to this much trouble over something so insignificant.

Now go and fix your buzz coil tester.

Paul

----- Original Message ----- 
From: "Andy" <rustyiron at bigpond.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Saturday, September 17, 2005 7:18 AM
Subject: Re: [SEL] Air Blow Off Nozzel Modification


> Hi Paul, Why don't you ask one of your mate in Australia (where we don't
> have this restriction) to send you one? I bet one of us owes you a favour 
> or
> two?
> Andy.....
>
> Andy Nicholson
> Exmouth W.A.


_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel



More information about the sel mailing list