[SEL] Cast iron repair

[MaytagTwin at aol.com]

Another possibility is to braze, clean, then spread a thin layer of JB Weld 
and wait a short while.  Before it hardens, but after it is no longer sticky, 
use a textured pad like a 3M pad and push it into the JB Weld, leaving a rough, 
cast iron like, finish.  After paint, you should have the appearance you want.

Regards,
Ron Carroll
Clearmont, MO USA

In a message dated 3/14/2005 2:12:00 PM Central Standard Time, 
George_Best at adp.com writes:
I know a guy who had some engine parts fabricated.  The person doing the
fabricating used a needle scaler to give the parts some texture and the
results looked very good.

WAIT George