[SEL] Baker Monitor update.

[mullt at att.net]

Curt,

For those of us who are new to working on old engines, your pictures are a great resource. Thanks.

Tom in St. Louis
 -------------- Original message ----------------------
From: Curt <curt at imc-group.com>
> Have been working on making the cart rails from wood sent by Richard 
> Fink. The list comes thru again!
> 
> Also Saturday was the day to make a special fixture to ream the intake 
> valve guide oversized to eliminate the badly worn condition. On a Baker 
> Monitor the intake valve and exhaust valve sit in line with each other. 
> Machining them is a challenge. On this link you'll see both the wood 
> working on the cart rails and the intake valve reaming fixture. Here is 
> the link and at the bottom look for 7/11/05 update:
> http://www.oldengine.org/members/holland/images/DevinsBakerMonitorRebuild/Thumbn
> ails.html
> 
> I have a question....what is a good material to use between the upper 
> part of the main bearing caps and the block to provide a seal?
> 
> Hope you enjoy.
> Curt Holland
> Gastonia, NC
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel