[SEL] Baker Monitor update.

[Curt]

Have been working on making the cart rails from wood sent by Richard 
Fink. The list comes thru again!

Also Saturday was the day to make a special fixture to ream the intake 
valve guide oversized to eliminate the badly worn condition. On a Baker 
Monitor the intake valve and exhaust valve sit in line with each other. 
Machining them is a challenge. On this link you'll see both the wood 
working on the cart rails and the intake valve reaming fixture. Here is 
the link and at the bottom look for 7/11/05 update:
http://www.oldengine.org/members/holland/images/DevinsBakerMonitorRebuild/Thumbnails.html

I have a question....what is a good material to use between the upper 
part of the main bearing caps and the block to provide a seal?

Hope you enjoy.
Curt Holland
Gastonia, NC