[SEL] Seneca Falls Lathe Info??

Peter A Forbes diesel at easynet.co.uk
Sat Jan 8 12:15:46 PST 2005


On Sat, 8 Jan 2005 11:45:54 -0800 (PST), you wrote:

>Thanks for the input folks,
>
>Peter,
>This lathe has an enclosed gear box.  It ain't like the other ones with a door that opens up to
>manualy change the gears.
>
>Move one lever until it is below the colume that has the desired threads in it, then pull out a
>knob and move it to one of three holes.
>
>The link I gave to see a picture shows those two adjustments on the left side of the lathe.
>Now if I can just figure out what Stud they are talking about,,,,,,
>
>I just went down there again and I still don't see a stud to play with around the gear box.
>
>????? Alan

Have you got a label like:

http://www.lathes.co.uk/senecafalls/page8.html

Peter

The studs are mentioned there, including 48, which is what I was referring to.

If you haven't, I'll keep on looking.

Peter





More information about the sel mailing list