[SEL] John Deere H

[Bill Brueck]

both valves .015 hot

rod bearings .001 - .003

B²
Bill Brueck (brick)
Chatfield, Minnesota USA

Confusion is a higher state of knowledge than ignorance.
----- Original Message ----- 
From: "Dave Ernst" <shop at cccomm.net>
To: "Engine List" <sel at lists.stationary-engine.com>
Sent: Friday, November 12, 2004 3:27 PM
Subject: [SEL] John Deere H


I have taken on a project for an acquaintance that owns this H. He has had
it apart for more than 5 years and admitted that he was in over his head. He
purchased th overhaul kit and has had the head an valves done. What I need
to know if anybody out there knows what in intake/exhaust clearances are and
what the rods bearings should be set at.

Thanks in advance
Dave
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel