[SEL] Maching blank pistons

[curt at rustyiron.com]

J.B.
The method described works well if (and that's a big if) the core didn't
shift in molding/pouring operations! My experience is some shift of the
core mold does occur. Especially on horizontally cast pistons.
The vertical patterns you use are a nice improvement.
Curt Holland
Bessemer City, NC



> This link should get you to a good article.
>
>
> http://wewilliams.net/docs/1925%20-%20The%20Correct%20Way%20to%20Machine%20Oversize%20Pistons%20-%20Bulletin%20No%2085.pdf
>
> J.B.
>
>
>
>
>
>
>
> On Mon, Apr 22, 2013 at 6:36 AM, Peter Lowe wrote:
>
>> Do we have any members who have a web site that shows the steps for
>> machining blank pistons and making rings?
>>
>>
>> Regards
>> Peter Lowe
>> R&V Engine Registrar
>> http://www.oldengine.org/members/plowe/rv-engines/rvpage.htm
>> Australia
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>