[SEL] Drip oiler check ball

[Bill Brueck]

I had good luck reseating the check ball on a hydraulic jack using common
valve grinding compound.  The ball was a lot harder than the seat so for all
practical purposes the grinding all took place on the seat and the ball was
unchanged.  It's been a while but I think I crammed the ball into a piece of
tubing to get a handle on it to grind with.

Bill Brueck
   Pine Island, MN USA


-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Richard
Strobel
Sent: Thursday, June 14, 2012 9:39 AM
To: The SEL email discussion list
Subject: [SEL] Drip oiler check ball

Howdee gang;
   What's the best way to re-seat the checkball on a drip oiler?

Thanks much
RickinMt.
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel