[SEL] Corey Bell's repro lunk mixers

[Richard Strobel]

Many thanks for the reply, Miles.  And which size did you use?  I imagine it 
was a left hand model.

Rick


----- Original Message ----- 
From: "Miles Hamrick" <mjhamric at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Friday, November 04, 2011 9:23 AM
Subject: Re: [SEL] Corey Bell's repro lunk mixers


Dick,

I just ordered one for him for my 5hp Galloway and it is nice. His contact 
information is as follows:

Corey Bell
12508 Longhorn Ave.
Sapulpa, OK 74066
Phone: 918-227-4407

His pricing model is as follows:

1/2 inch=$95
3/4 inch=$135
1 inch R.H.=$180
1 inch L.H.=$180
1 1/2 inch R.H.=$195

Add $10 for shipping charges. He is a super nice guy to deal with and very 
helpful.

Miles
Shelby, NC


________________________________
From: Richard Strobel <Richard_Strobel7 at msn.com>
To: stationary-engine <stationary-engine at oldengine.org>; The SEL email 
discussion list <sel at lists.stationary-engine.com>
Sent: Friday, November 4, 2011 10:52 AM
Subject: [SEL] Corey Bell's repro lunk mixers

G'day all;
Is Corey still around as I'm looking for a mixer for our newly acquired
9hp Galloway.
or any of you have one stuffed away and looking for a new home. I believe
it will be around inch and a quarter npt.

TIA
RickinMt.

_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel