[SEL] Wooden spray tank repair.

[Keith Kinney]

Ron
Check out this link.  I'll bet it will be useful in your project.
Keith
http://www.smokstak.com/forum/showthread.php?t=48397

On Sep 21, 2010, at 1:51 PM, rdhaskell at juno.com wrote:

> Hi all.
> Anyone on the list ever replaced the wood on an old tank for a spray rig?
> This one is about 4' long, 3' wide and 3' deep.  Round on the bottom and
> held together with metal rods.  My question is about the long boards  on
> the sides, the remaining boards are not tongue and groove they just butt
> together and rely on the wood swelling up.  These boards have a slight
> curve across their width, were them made that way or over the years of
> being wet and clamped in place did they curve?
> A lot of the original wood is there but saturated with arsenic and now
> hazardous material and cannot be used.
> Thanks for any suggestions.
> 
> Ron Haskell
> rdhaskell at juno.com
> Riverside, California USA
> http://picasaweb.google.com/RonHaskell
> ____________________________________________________________
> Mortgage Rates Hit 3.25%
> If you owe under $729k you probably qualify for Obama's Refi Program
> http://thirdpartyoffers.juno.com/TGL3141/4c98feffc24ecd02c6st03vuc
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel

Keith Kinney
kkinney at herculesengines.com
WWW.HerculesEngines.com