[SEL] Drag line engine ID wanted

[Rupert]

	I wish I knew. We haven't found any markings on the crane so far but we 
haven't been able to get a good look inside yet as the door is seized. 
Lots of parts have enough crud on them to hide a name plate too. Hope to 
get to it again this week end with some penetrating oil to try to free 
up the door. I also hope to get a better look inside. But, the weather 
is turning sour here so plans may have to change. The dragline is about 
25 miles away.

Rupert

On 11/15/2010 4:24 PM, frank skinner wrote:
>
>
>
>   Rupert;
> Whats the make of the crane ?
>
>                    Best Regards
>
>             Franklin S. Skinner
>        Marine Surveyor&  Consultant
> 3428 Talon Court Wilmington NC 28409
>         34'10.9 North 74'52.4 West
> PH 910-791-8870  Cell 910-612-7470
>
>
>
>
>
>
>> Date: Mon, 15 Nov 2010 10:14:14 -0700
>> From: rwenig2 at xplornet.com
>> To: sel at lists.stationary-engine.com; at at lists.antique-tractor.com
>> Subject: [SEL] Drag line engine ID wanted
>>
>> Hello Group,
>> My son-in-law acquired a dragline on the week end. I posted a picture
>> at<http://users.xplornet.com/~rwenig/Pictures/Drag%20line.jpg>  He would
>> like some help confirming the brand or maker of the engine.
>> Also, he is looking for a magneto for the engine as the mag is missing.
>> Any help appreciated.
>>
>> Rupert
>> --
>>
>> yvt
>>
>> Rupert Wenig
>> Camrose, Alberta, Canada.
>>
>> email: rwenig2 at xplornet.com
>>
>> http://users.xplornet.com/~rwenig/Home/
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>   		 	   		
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>

-- 

yvt

Rupert Wenig
Camrose, Alberta, Canada.	

email: rwenig2 at xplornet.com
	
http://users.xplornet.com/~rwenig/Home/