[SEL] E&B help needed

[frank skinner]

Curt;

Are you saying that the valves are in cages ?

 

                    B, Rgds

        Franklin S. Skinner 
    Marine Surveyor & Consultant 
3428 Talon Court Wilmington NC 28409 
       34'10.9 North 74'52.4 West 
PH 910-791-8870 Cell 910-612-7470



 
> From: cgandree at mchsi.com
> To: sel at lists.stationary-engine.com
> Date: Sun, 27 Sep 2009 13:57:10 +0000
> Subject: [SEL] E&B help needed
> 
> Hi All,
> My Emerson Brantingham, model "H", 1 1/2hp had developed a blow by thru the intake valve. So yesterday I took it to a engine friends tractor repair shop and we dissassembled, ground, lapped and seated both intake/exhaust valves, also put in a new set of rings. We continued to get blow by thru the intake valve so took apart and relapped with still no change in blow by. Timing is right on. By some trial and error and taking intake valve off and on at least ten times we decided to not tighten up the three bolts holding the intake asy in place.........the blow by stopped. Now the there is an air leak around the cage of the intake and engine does run some what. Was wondering if any one has one of these engines or had similiar experience. All areas have been cleaned and the mating surfices are polished and true, we are not seeing any signs of warpage. Sure could use some help and ideas.
> Thank you in advance.
> Curt Andree
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel