[SEL] O.T. O.T. Need Help On Water Flow Problem

[MaytagTwin at aol.com]

Hi Paul,
 
Get a handful of stainless sheet metal panhead screws  that will thread 
into the holes you have made.  Use your small pocket knife  blade to make a 
notch in the side of each hole in the pvc that the panhead can  just cover.  
Don't worry, if you make it too large just use a flat washer  with the screw.  
 
Notch all the holes, install the screws, run the  rectangle full of water 
and then begin adjusting the flow individually  until  you are satisfied.
 
Regards,
Ron Carroll
Clearmont, MO
 
**************We found the real ‘Hotel California’ and the ‘Seinfeld’ 
diner. What will you find? Explore WhereItsAt.com. 
(http://www.whereitsat.com/#/music/all-spots/355/47.796964/-66.374711/2/Youve-Found-Where-Its-At?ncid=eml
cntnew00000007)